Bonne Nouvelle: Winter Wonderland Wands

In January my daughter celebrated her 5th birthday in real fashion. She wanted a peacock tea party and I wanted Alice in Wonderland. So we had a Winter Wonderland Alice in Wonderland Peacock inspired tea party. I was waiting for someone to request how I made the wands before I shared the tutorial. I apologize it is so late coming but perhaps you'll be able to use it for your own daughter's fairy wand or winter wonderland party. They take less than 10 minutes to make one and probably about $1 for materials. To be honest, these are not the most sturdy of wands. The snowflakes are fragile and the straws bend over time. But for the purposes of a pretty party favor or just dancing around magically like my daughters' like to do, they are simple to make, fun and inexpensive.

I have two variations. Ready?

VARIATION #1

PAPER STRAW WAND

1. Materials: You'll need hot glue (not pictured), ribbon (about 20" long, 2 pieces), a paper straw, a wooden skewer, a Q-tip and a snowflake on a stick (I found this at Joann's for about . If you cannot find this I have also used $1 Tree snowflakes that are not on a stick, just glued it to the wand).

2. First, cut your skewer to just shorter than the straw. Then cut the Q-tip in half. Slip the skewer in the straw and then shove one of the Q-tip pieces along side it, this is the bottom of the wand. Slide up the straw so you can't see them.

3. Then, place the other Q-tip alongside those two pieces so it's nice and snug.

4. Next, flip the wand over. You'll put a dab of hot glue on the top of the straw and gently slide the snowflake inside. It should slide right along side the skewer. Glue in place.

Slide flake down until the tip of the snowflake fits snugly inside the straw.

4. Then, add the ribbon. I can't remember the name of this knot. Maybe it doesn't even have one?

5. Then put a dab of glue underneath the ribbon to hold in place. And you're done!

VARIATION #2

Dowel Wand

1. Materials: Hot glue, snowflake on a stick, wooden dowel (about 12" long. I found mine at Joann's in a pack of 10 or so) and long piece of ribbon (about 1 yard) plus extra of same or contrasting color for the end.

2. Put a dab of hot glue on the dowel and glue snowflake in place.

2. Next, start adding the ribbon. Put glue over the snowflake stick and dowel about an inch at a time, on three sides of the dowel. Careful, don't burn your fingers as you gently press the ribbon in place over the glue. Gently pull the ribbon taut as you twirl the ribbon around the wand over the hot glue. Or you could twirl the wand as you hold the ribbon in place. Either way works. Whichever you're most coordinated with. Be sure to overlap the ribbon over itself a bit so the wood doesn't show.

3. Glue ribbon all the way down the dowel. When you get to the bottom, cut any excess ribbon and glue in place by overlapping a few times. Then tie the ribbon (as many as you'd like) around the bottom of the snowflake in a knot. Glue in place.